New Model, need helping naming it.

J

J. Hoover

Feedback: +61 / =0 / -0
Joined
Jul 2, 2006
Messages
1,782
Thanks to everyone for your input on the name. You all had some good ideas, I have decided to use a couple of the names combined. From now on this model will be known as the Rigdeback Tactical Hunter

I sat down the other day after supper and penciled out some designs, I work best when my stomach is full. This is one of them, my thoughts were to create something with a mild tactical look but still be useful as a hunting or edc blade. Anyway this is what I decided on, now it needs a name. So tell me what you would call it, other than ugly,hehehe.
Here's the run down:
Steel- O1 X 3/16 Tool Steel
Ht- My standard heat treat for O1, triple drawn.
AOL- 8 7/8 inches
Blade- 4 1/2 inches to tip on scales with a 3 1/2 inch cutting edge.
Handle- 4 3/8 inches
Scales- Some of Tracy's canvas micarta with blood red spacers.
Stainless corby rivets and stainless lanyard tube.
This knife will come with a leather sheath, your choice right or left. I have not made it yet, there are plenty of pics of my sheath work if you check my post.
I'm asking SOLD shipped in the USA and Canada.
Paypal or USPS M/O preferred.
Thanks for looking.

IMG_0798_1.jpg


IMG_0799_1.jpg


IMG_0801_1.jpg


IMG_0802_1.jpg


IMG_0803_1.jpg


IMG_0800_1.jpg
 
Last edited:
I'm almost tempted to say that it should be called,

'TiNi's Knife'

Joe,

could you make a sheath with a slight 45' degree angle for belt carry (if that makes sense).

Ive seen a similar style sheath somewhere............. but where, need to look for it.
 
Last edited:
Denim's Multi-Grip & Skinning-Clip

No need to thank me. Well, unless the winning name gets one of those bad boys ;) Seriously, neat design and should be very useful in many applications.
 
Last edited:
You must log in or register to reply here.
Back
Top