Blasted Hill Knives
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2015
- Messages
- 1,421
Hi everyone!
I am happy to introduce a new model called the Stormlight which is an edc knife from 5/32” thick AEB-L stainless steel! This is the first one I built and thus it is the prototype - I have already decided to make a few minor changes to the final version. Therefore this will be a one of a kind knife.
This one is 6 1/2” overall with a 3” full flat ground blade. The knife is 1 1/8” wide at its widest point and only 1/2” thick for a nice slim carry. The scales are red G-10 and the pin is battleship grey G-10. The lanyard tube is brass. The knife is acid etched and stonewashed and the handle and top of blade flats are rock-carved. The knife comes with a custom kydex sheath.
This one is $OLD shipped USA! (Probably a bit less than what the final version will run.). I accept PayPal F&F, money order or personal check.
I hope you like this new model! Comments and questions are always welcome!
Thanks,
Mike
I am happy to introduce a new model called the Stormlight which is an edc knife from 5/32” thick AEB-L stainless steel! This is the first one I built and thus it is the prototype - I have already decided to make a few minor changes to the final version. Therefore this will be a one of a kind knife.
This one is 6 1/2” overall with a 3” full flat ground blade. The knife is 1 1/8” wide at its widest point and only 1/2” thick for a nice slim carry. The scales are red G-10 and the pin is battleship grey G-10. The lanyard tube is brass. The knife is acid etched and stonewashed and the handle and top of blade flats are rock-carved. The knife comes with a custom kydex sheath.
This one is $OLD shipped USA! (Probably a bit less than what the final version will run.). I accept PayPal F&F, money order or personal check.
I hope you like this new model! Comments and questions are always welcome!
Thanks,
Mike
Last edited:
