New Years Textured 1095 cutter

C.Edmondson

C.Edmondson

Feedback: +18 / =1 / -1
Joined
Jan 22, 2009
Messages
1,114
SOLD.Heres one just finished up after really bad back problems, forged finish 1095, bacote handle contoured really nice,Ricasso is 3/8, 14 3/8 total lenght blade at widest point is 1 7/8, top of guard to the tip is 9 inches, top of guard to the bottom of the handle is 5 1/2 inches. Clip is sharpened but not razor sharp. Basically this is a simple straight to the point cutter, if its not suppost to be sharp its left forged. Price for the first sell of the New Year is SOLD shipped priority, soft case included
 
Last edited:
Thanks for the nice comments, the blade is hardened and tempered. The hamon is real active on the blade but it was not clay coated just edge quenched at 1480 deg, and tempered twice at 430 for 1 1/2 hours.
 
You're going to be seeing an awful lot of this one in the future I suspect. ;)

'cause I'm going to use the heck out of it and tell you all about it. :D

B
 
Thank yall very much for the nice comments, Hey Will, this isnt the one, that one was a 5160 bowie, I still gotta finish, again thanks to everyone,Charlie
 
Charlie,

I got her today and put my initial thoughts up here on my blog.

Edmondson_01.jpg


I can't wait to get it out and start putting it to work.

Thanks again,


B
 
You must log in or register to reply here.
Back
Top