Newbie David Lee

C

cottonlee

Joined
Sep 5, 2015
Messages
12
Hi, Don't know much about anything. Just got my first grinder, Pheer, going to work on it after church, got it wired up, motor bolted down, going to move it from garage to basement for winter, any suggestions about anything would be greatly appreciated. Thank You, glad to be here.
 
David.....


Post in the sub forum General Knife makers Questions they're able to assist you better
 
I suggest , if you haven't, that you read the "stickies" at the top of the page. They will have answers for most of your questions.
Frank
 
Last edited:
And when you get to the metallurgy section you will need a big bottle of aspirin too. :)
 
You must log in or register to reply here.
Back
Top