O-1 and Ironwood integral Drop point

steelshaper

steelshaper

Feedback: +12 / =0 / -0
Joined
Jun 14, 2007
Messages
835
Well guys I have been slacking a bit. Just been burnt out.:( I got to this point where I didn't like anything I made anymore and aside form trying to finish up orders I haven't made much of anything. I think my skill to knowledge ratio got out of whack and so did my confidence. But we must push on, move forward, and the only way to do that is to keep making em. :thumbup:

This is a knife that took me to long to make. Such a cool bugger though if I do say so myself. It was forged from 3/4 O-1. Charcoal forge not that that really matters. It has some very Dark Ironwood for the handle scales.
It is flat ground has stainless pins and tube. Blade is 5/32 thick with a taper 3 3/4 long and just under 8 overall. There is a bit of recurve. Includes the sheath in the picture and postage for SOLD $175.00 SOLD Can take paypal. Thanks

ddii.jpg


ddi.jpg
 
Last edited:
Another beauty. I've always admired the clean, elegant look of your forged integrals. If my funds weren't already spoken for I'd be all over this one.
 
That's a beautiful knife, the lines are very attractive. However long it may have taken, it looks great!
 
Dinokay Lets call it yours then. I can take paypal to will@crumpsforge.com Or if you would rather a M.O. I can email you my address. Thanks

And sorry to those interested in this knife that missed out.

And a big thank you to all the people posting the kind comments.
 
You must log in or register to reply here.
Back
Top