Oil Drip System for Milling

[Pittknife]

Hi Guys,

I have a Grizzly G0704 I use for milling designs on my titanium handles. I have been searching and can't find a oil drip system besides the one from micromark which has a very bad review and also the cobra system from Grizzly (it has a foot pump). I have a kool-mist system but I'm pretty tired of my compressor being on all the time, and I don't have room for a larger compressor (currently 21 gallon).

Can anyone recommend a good drip system or an alternative? From what I read I don't think my space will work with a flood coolant system.

 

[polish avenger]

This one is awfully small....just one gallon of coolant capacity.
http://littlemachineshop.com/products/product_view.php?ProductID=3520
-Mark

 

[Pittknife]

This one is awfully small....just one gallon of coolant capacity.
http://littlemachineshop.com/products/product_view.php?ProductID=3520
-Mark

Thanks man but that is a flood system, I want a drip system with a pump to control the rate.

 

[Kosa_PL]

Hey,

Did you considered MQL cooling system ?

You can DIY this!
Look at my topic: http://www.bladeforums.com/forums/s...Fogless-cooling-for-surface-and-belt-grinders
But use needle valves with small taps like M5 ( or it's Imperial brother).
I doing now better version of this, and I'll post results in that topic.
You can use this with : Oil, Water, Micro-emulsion.

And it's a lot better than Kool-Mist, there is no FOG.