G L Drew
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 3, 2005
- Messages
- 4,794
An EDC in damascus from a 120 layer billet that I forged from 1084 and 15N20 high carbon steel
Heat treated in Evenheat furnace to Rc 58-60 with three normalizing and two tempering cycles creating a fine grain structure throughout the blade
Flat grind
Stabilized and dyed maple burl handle
9 1/4 inches overall with a 5 inch blade
Blade thickness is approximately 1/8 inch at the index finger and one inch deep with a distal taper to the tip and edge
Oiled leather scabbard with a belt loop for a right hand carry
$230 delivered within the US My PayPal and email address is gldrewknives@gmail.com
Please do not us the word "damascus" in a payment. PayPal would be required to hold it up for review; sometimes for weeks.
IMG_6081 by Gerald Drew, on Flickr
IMG_6079 by Gerald Drew, on 
IMG_6082 by Gerald Drew, on FlickrFlickr
IMG_6080 by Gerald Drew, on Flickr
IMG_6083 by Gerald Drew, on Flickr
IMG_6078 by Gerald Drew, on Flickr
Heat treated in Evenheat furnace to Rc 58-60 with three normalizing and two tempering cycles creating a fine grain structure throughout the blade
Flat grind
Stabilized and dyed maple burl handle
9 1/4 inches overall with a 5 inch blade
Blade thickness is approximately 1/8 inch at the index finger and one inch deep with a distal taper to the tip and edge
Oiled leather scabbard with a belt loop for a right hand carry
$230 delivered within the US My PayPal and email address is gldrewknives@gmail.com
Please do not us the word "damascus" in a payment. PayPal would be required to hold it up for review; sometimes for weeks.
IMG_6081 by Gerald Drew, on FlickrIMG_6079 by Gerald Drew, on IMG_6082 by Gerald Drew, on FlickrFlickrIMG_6080 by Gerald Drew, on FlickrIMG_6083 by Gerald Drew, on FlickrIMG_6078 by Gerald Drew, on Flickr
