Bill Siegle
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 3, 2000
- Messages
- 6,814
Here is a one of a kind Choora. It is a single edged stiletto design that was used in the middle east way back when. Mine is made from 5160 and jade green G10. I used mosaic pins too 
The steel is a shade over 3/16 thick and I ground it with full flat bevels to a zero edge and then the burr was removed at 20 degrees on a Sharpmaker. Sheath is Kydex with a Tek Lok belt attachment. I had this one priced at $275 but decided to blow it out since the Holidays are almost upon us so $200***SOLD*** gets it shipped in CONUS(USPS MO or Paypal+4%)
The steel is a shade over 3/16 thick and I ground it with full flat bevels to a zero edge and then the burr was removed at 20 degrees on a Sharpmaker. Sheath is Kydex with a Tek Lok belt attachment. I had this one priced at $275 but decided to blow it out since the Holidays are almost upon us so $200***SOLD*** gets it shipped in CONUS(USPS MO or Paypal+4%)
Last edited:
