Personal Mini Safe -Stainless Steel Body - MEDECO Lock

Status
Not open for further replies.
bladeknot

bladeknot

Gold Member
Feedback: +440 / =0 / -0
Joined
Feb 14, 2011
Messages
4,909
ALL SOLD: Personal Mini Safe, rust proof stainless steel body, Medeco lock. Dimensions as pictured below: width 8.875", height 5.28", depth 11". Very high quality drill and pick resistant lock. Hardened steel plates in the lock; and one angular cut key included. Can be drilled and bolted to a wall or shelf; or installed in a truck or boat. These were originally designed to be installed in a vehicle, and the original cost was $350 ea. Asking $75ea. (used w/ some blemishes. Also the leg that sticks out to the bottom can be bent a little.) shipped priority 2 day air, USA, PayPal. All sold.
oiH3nr.jpg

All Sold:
2) s2324 Sold, shipped
3) s2324 Sold, shipped
4) s2324 Sold, shipped
5) s2324 Sold, shipped
7) tacticalgonzo Sold, shipped
8) Nfd538 Sold, shipped
9) Crow-Bar Sold, shipped
10) greg c - Sold, shipped
12) Dawkind -Sold
Passed:
1) ltn369 payment info posted here, visitor message sent, tapatalk message sent. Haven't heard from them in 5 days, though they have been on the forum, so I'm assuming that they have passed on this.
6) Destine2devoid -passed
11) GIZMOMAN - passed
*********************************************************************************
Stand by list:
13) knifenut880
14) Premium Cut
15) Premium Cut

Fine print: I have described these the best that I can. Please see all pics. These are used, and as such may have some damage, a blemish or slightly bent leg. No returns. Not responsible for loss or damage in the mail.
 
Last edited:
Total weight with packaging is ~10 lbs. It's sheet steel. Its light steel for a safe, however strong stainless for a lockbox. The sides or bottom can be drilled through and a lag bolt and washer could screw the safe directly into a wall stud. Or laying on its side, drill through the bottom and bolt it to a shelf. You could even use it as a floor safe as the unusual bottom would set in concrete and hold well. The door is spring loaded. There is a stop pin attached to the inside with a chain. When opened, the stop pin can be pulled out, and placed in the small hole in the side. This holds the door open. Also, when the door is closed, an additional lock can be run through the same hole, double locking the door closed. A note about keys: Only one is provided. Duplicates can only be ordered by contacting the original manufacturer, (I can supply you with the contact info) and they are costly!This is because the MFG. has exclusive rights to the keyway; and only they can get the proper blanks from Medeco. this is a security feature. Interior shot:
rLlAOk.jpg

and more pics:
UcmkwG.jpg
5ir8A5.jpg
AFFVC4.jpg
UdJZex.jpg
ErqPbU.jpg
 
Last edited:
ltn369 and tacticalgonzo

Payment info: Please see original post for payment info, and Thank you!
 
Last edited:
Email sent for multiple safes.

I will take 4 if you have that many.
====
Payment sent for 4 units.
 
Last edited:
The interest list is in the original post.
If interested post in this thread and I will add you to the list.

There are nine available, see original post. Six people have posted an "I'll Take it" and three others have shown interest. All nine have been contacted and have 24 hrs to send funds. Then we will move down the list.

Bottom line: please post in this thread if interested and I will ad you to the list.
 
Last edited:
Nfd538, you are on the list. Please send payment and your mini safe will ship tomorrow AM. Thank you.


Sent from my iPhone using Tapatalk
 
Status
Not open for further replies.
Back
Top