- Joined
- May 19, 2013
- Messages
- 185
I'm thinking of using an arbor press to drive my bolster pins, but instead of peining the pins, would the pressure from the arbor press expand the pin ends in a controllable manner? Has anyone tried this?
Also, should I use a shallow counter sink for the pins to expand into, or would a steep burr cut be stronger?
Feel free to direct me to your favorite thread on bolster construction, btw. Thanks.
Also, should I use a shallow counter sink for the pins to expand into, or would a steep burr cut be stronger?
Feel free to direct me to your favorite thread on bolster construction, btw. Thanks.
