- Joined
- Apr 13, 2007
- Messages
- 12,294
I decided to try a little battoning with Kgd's RC4 today. The full taper blade lets it sink deep into the wood with ease.....
I'm ashamed to say at this point I looked at the thin section of tip poking out of the side of the wood and then pictured my e-mail to Kgd explaining how the tip had snapped off when struck with my batton so I bottled it and knocked it back out !!!
It did go through this smaller section with no trouble though so it may have been all right after all !
Now back to the larger section using my DM....no way that tip is gonna snap !!!
Here is a thickness comparison pic with the RC4, my DM and my Bandicoot...
I then tried making a fuzzstick again to see how it compared to my Bandioot...
They were very close in performance but I would just give the nudge to my Coot as it felt a little comfier in use and a little easier to control !!!
I'm ashamed to say at this point I looked at the thin section of tip poking out of the side of the wood and then pictured my e-mail to Kgd explaining how the tip had snapped off when struck with my batton so I bottled it and knocked it back out !!!
It did go through this smaller section with no trouble though so it may have been all right after all !
Now back to the larger section using my DM....no way that tip is gonna snap !!!
Here is a thickness comparison pic with the RC4, my DM and my Bandicoot...
I then tried making a fuzzstick again to see how it compared to my Bandioot...
They were very close in performance but I would just give the nudge to my Coot as it felt a little comfier in use and a little easier to control !!!