Pocket Knife Shields

[Don Hanson III]

I had Mark at Leading Edge water jet cut a bunch of shields recently, 400 to be exact. Really more than I needed. And two of them are almost identical. So I need to sell some. In the photo is a piece of ivory that I inlayed two shields, using both plates and a 1/16" high speed steel endmill. Ivory is the most unforgiving material to inlay into, because it shows bad if it's not a tight fit. This is the best quality water jet work I've used. Mark does great work!

100 shields, cut from .060" 416 stainless steel.

Two parser plates cut from 5/32" 1095 and heat treated by me.

I need to get $1.25 each for the shields and $35 each for the plates and $5 shipping.

Total for all, $200 shipped Priority mail. SOLD THANKS

Paypal to; info@sunfishforge.com

Thanks!

 

[John L]

Don: I'll take them please.

John Lloyd

 

[Don Hanson III]

You got it, John.

Thanks!

 

[Bruce Bump]

That's allot of small bull scrotums One of my favorite shields.

 

[Don Hanson III]

Bruce, I ended up with too many. But I do like this shield.