Power Hammer For Sale

[M.Griffin]

I am moving soon and am going to have to part with my power hammer. I was told it was built in the 1950s in the Carson City, NV blacksmith shop. The hammer has lots of character and you won't find another one like it. I purchased it a few years back and have used it a lot without any problems. I replaced the motor (single phase, 2hp, 110v or 220v), made some dies for it, and gave it a paint job. It is a 60lb hammer and it hits good and hard. The entire hammer weighs 1600lbs so we might have to get creative to load it on a trailer. The hammer is set up right now so if someone is interested, I will be able to let you run the hammer to try it before you buy it. I am looking to get $1700 for it. Thanks.

The hammer is located about 45 minutes North of Sacramento, CA.

-Mike

 

[M.Griffin]

If anyone is interested, let me know and we can talk.

-Mike

 

[bacustomknives]

if you wernt so far away bother

 

[silverforgestudio]

MGriffin- If you could get that in a flat rate box I would have snatched it already... Do you have an email- Tried to PM but it did not go thru- Im on the OPPOSITE side of the map... but may have a contact for you.

Kerri

 

[M.Griffin]

Kerry,
Check your pm. Not sure why it didnt go through.
-Mike

 

[Fatherof3]

Hi Mike
wondering if it is still with you? 3/25/14
Tim

 

[M.Griffin]

The hammer is sold.