- Joined
- Jul 28, 2020
- Messages
- 472
I'm a little tight on cash right now, otherwise I wouldn't be letting this one go. This knife punches WAY above it's weight class, chopping as though it was a much larger knife. David made this to be a workhorse and it shows. The finish is not superb and there is a tiny blemish on the handle, but this knife doesn't care, It's just too dang busy chopping. Not to mention that David is one of the nicest people on the forum.
David made this little monster out of 5/32" thick 1084 that has been professionally heat treated to 61HRC. It is 9 1/2 inches long with a 4 3/4 inch cutting edge. David is such a nice guy he even wrote down the edge geometry: 2/3 convex, 15° primary edge, 20° micro, .028" behind the edge. It weighs 7.9 oz and is handled with OD green and black canvas micarta, with red G10 and black paper micarta liners. I also comes with an OD green Kydex sheath.
Asking $185 Paypal F&F to scarysamcary@gmail.com (My account is not set up for G&S, but I will stake my account and reputation on you receiving your knife or being made whole)
David made this little monster out of 5/32" thick 1084 that has been professionally heat treated to 61HRC. It is 9 1/2 inches long with a 4 3/4 inch cutting edge. David is such a nice guy he even wrote down the edge geometry: 2/3 convex, 15° primary edge, 20° micro, .028" behind the edge. It weighs 7.9 oz and is handled with OD green and black canvas micarta, with red G10 and black paper micarta liners. I also comes with an OD green Kydex sheath.
Asking $185 Paypal F&F to scarysamcary@gmail.com (My account is not set up for G&S, but I will stake my account and reputation on you receiving your knife or being made whole)
