**Price Drop** 3.5" Rambler Belt knife - D2, Stick Tang, 3-piece wood handle

[Bill Drake]

Happy Monday everybody!
This was one of my first postings on the site and the first of (5) I made of this model (3 posted to date), so I wanted to get this great little tool back out there to you all.

D2 at 61-62hrc w/ robust stick tang, 0.149" at spine x 1" tall, 8-3/4" OAL, weighs 5.2oz
High sabre grind (near-full flat), hand rubbed to 600 grit.
Handle: 3-piece, mechanically connected, with red-wht-blk g10 spacers and hand-rolled burlap pin. Nicely contoured and hand-filling.
Outer sections are, I believe, Cherry (?) branches (ring-cut) I acquired a few years ago. These sections cracked a little during torching (clearly visible), but I believe they will not be an issue under normal use...obviously not a chopper...
Mid section is probably Walnut (?), taken directly from unfinished rifle stock.
(Again, NOT stabilized, but multiple cycles (over several weeks) with tung oil to saturate after torching)
**If there is an issue with the wood, I will do what I can to make it right.**

Hand made leather sheath (right hand carry) dyed to roughly match the handle...



Humbly asking $175 $160, shipped insured CONUS. Venmo, Zelle or Paypal.

Thanks for looking!
Bill

 

[jfk1110]

Handsome pair.

 

[Bill Drake]

Handsome pair.

Thank you James!