- Joined
- Aug 31, 2011
- Messages
- 3,121
To make this knife, I bought a ready made blade, then made a handle and sheath for it. This item is new. Never carried, sharpened, or used.
Blade: Brusletto 7 cm. Stainless. There are a few hairline scratches on the right side of the blade, and one small scuff on the left side. The scuff is about 1/16"X1/32". These are barely noticeable flaws, and do not affect performance.
Blade dimensions: 2 3/4" long, 9/16" wide, .072" thick.
Blade hardness: 58-59 Rockwell.
Handle: Stabilized Maple from AKS, and fiber spacer. In the pictures, it looks like the wood is scuffed. That's just glare.
Sheath: Leather with wood insert. Protected with Sno-Seal. There is some discoloration on the leather, which I could not fix.
Knife OAL: 6 1/8".
Combined Weight of Knife and Sheath: 3.3 oz.
Finish: Tru Oil.
$25 shipped anywhere in the U.S. Add $2 for Canada.
I don't check my PM's very often so either post a reply here or send email.
--squid
Blade: Brusletto 7 cm. Stainless. There are a few hairline scratches on the right side of the blade, and one small scuff on the left side. The scuff is about 1/16"X1/32". These are barely noticeable flaws, and do not affect performance.
Blade dimensions: 2 3/4" long, 9/16" wide, .072" thick.
Blade hardness: 58-59 Rockwell.
Handle: Stabilized Maple from AKS, and fiber spacer. In the pictures, it looks like the wood is scuffed. That's just glare.
Sheath: Leather with wood insert. Protected with Sno-Seal. There is some discoloration on the leather, which I could not fix.
Knife OAL: 6 1/8".
Combined Weight of Knife and Sheath: 3.3 oz.
Finish: Tru Oil.
$25 shipped anywhere in the U.S. Add $2 for Canada.
I don't check my PM's very often so either post a reply here or send email.
--squid
Last edited: