Price Drop: Hinderer Gen. 6 XM-18 Skinner - Tri-way pivot (Old Logo!)

[BMCGear]

This is an XM18 3.5 and was purchased new by me from USAMadeBlade. It is running on bearings and flips well (in my opinion). The knife has the factory edge and will slice paper. It features the working finish and cpm20cv steel. Comes with the box, card, washers, and tactical peanuts. This is one of the earlier Gen. 6 models because it has the original tri-way logo on the flipper tab that was later changed.

Traded!

 

[dharmapunk707]

Is this a 3.5”? Appears to be, just checking

 

[BMCGear]

Is this a 3.5”? Appears to be, just checking

Yes, it is a 3.5!

 

[gmartin12]

Please only post in the thread if you'd like to buy the knife. Any questions pm me or shoot me an email using my forum name at gmail.


This is an XM18 3.5 and was purchased new by me from USAMadeBlade. It is running on bearings and flips well (in my opinion). The knife has the factory edge and will slice paper. It features the working finish and cpm20cv steel. Comes with the box, card, washers, and tactical peanuts. This is one of the earlier Gen. 6 models because it has the original tri-way logo on the flipper tab that was later changed.

$350 shipped

Is this a 3" or a 3.5" blade?
Also - would you be open to trades?

 

[gmartin12]

Yes, it is a 3.5!

Sorry...I must've typed in my question as you were replying.

 

[BMCGear]

Is this a 3" or a 3.5" blade?
Also - would you be open to trades?

3.5. I prefer cash - partial trades may be entertained.

 

[8-Fingers]

PM being sent!