PSKX in Stabilized Green dyed Maple Burl, Mosiac Brass and Leather

Landi

Landi

Feedback: +112 / =0 / -0
Joined
Mar 4, 2007
Messages
1,960
Hello BF,

Knife is sold. Thanks for looking.

OAL is 7 5/8, and cutting edge is 3 1/4. This knife has a full flat primary bevel.

Handle is Stabilized, green dyed Maple Burl.

Mosiac pin and tube are brass.

These O1 knives are heat treated, cryogenically treated, and tested to guaranteed Rc of 58-60 by Peters of Meadville, PA.

The sheath is made from 8/9 veg tanned shoulders, constructed by me. It is set up for right handed belt carry.

3168686216_b96ab27346_b.jpg

3167856653_317dab4916_b.jpg

3168686702_3be1906b68_b.jpg

3167857255_175cbb2d78_b.jpg


PSKX is $99, Paypal, MO, etc are fine. Shipping is free to Conus, I will ship internationally.

Thanks for looking, John
 
Last edited:
That is a stunner John! Pretty good price considering the handle material.
 
How About $99 and free shipping on this one?

I need some materials, to make more knives, to buy more materials... :-)
 
John, I'll take it if you can wait a few days for my paypal account to get transferred. I was a little too low to cover this amount but it should be deposited in a couple of days.

We need to get you those materials so I can get the other two knives that I ordered.:D

If this will work, send me your paypal info.

thanks John

JH
 
Jim Hall said:
John, I'll take it if you can wait a few days for my paypal account to get transferred. I was a little too low to cover this amount but it should be deposited in a couple of days.

We need to get you those materials so I can get the other two knives that I ordered.:D

If this will work, send me your paypal info.

thanks John

JH
Click to expand...

Fine with me Jim!

Email on it's way.
 
If Jim decides against it, I like to put in for this one thanks.I do live in the E.U. though but I'm sure something could be worked out.

Regards, W
 
Absolutely beautiful work John. I would be interested in the same style and handle material, if possible with 4 1/2 to 5 inch blade. Also willing to send you a check or MO ahead of time. Email me at hallauer@swnm.com and let me know if it's possible and the price. Thanks...Randy
 
YDNAR88030 said:
Absolutely beautiful work John. I would be interested in the same style and handle material, if possible with 4 1/2 to 5 inch blade. Also willing to send you a check or MO ahead of time. Email me at hallauer@swnm.com and let me know if it's possible and the price. Thanks...Randy
Click to expand...



Hey Randy,
I sent you an email last week to the address above, let me know if you didn't receive it.

Thanks for your interest.

John
 
You must log in or register to reply here.
Back
Top