Puukko !!!SOLD!!!

J

J. Hoover

Feedback: +61 / =0 / -0
Joined
Jul 2, 2006
Messages
1,782
Pics were taken prior to placing my mark on the blade, the blade does have my mark now.

Here is a puukko style knife that was made from 52100 flat stock. The profile was hand forged with the bevels ground stock removal. The tang runs the length of the knife and is peened to form a rivet. Heat treat was two normalizing cycles followed by two quench cycle and three 2 hour temper cycles. The blade was allowed to cool overnight between quenches. It has a fine polished convex edge that is shaving sharp. Here are the specs:

Steel- Aldo's 52100 X approximately 1/8 thick
AOL- 8 inches
Grind- Flat
Finish- Hand sanded to 1000 grit
Blade- 3 1/2 inches
Handle- 4 1/2 inches
Wood- Stabilized Claro Walnut Burl
Hardware- Brass with copper washer
Sheath- RH traditional pouch style
Asking 160.00 shipped
Paypal, USPS M/O, or Certified Check preferred. Email for other options
Questions or comments welcomed
Thanks for looking
The First I'll Take It in the post has it

001-92.jpg


002-94.jpg


003-89.jpg


005-83.jpg


006-76.jpg


008-55.jpg


009-44.jpg


010-47.jpg
 
Last edited:
Gorgeous knife dressed in that Claro Walnut with brass/copper fittings, beautifully finished! Exceptional sheath too!!
 
Thanks for comments everyone, now this one needs a hip to dangle from, Solid little knife with good heft and strength, plenty big enough for skinning medium size game.
Good to hear from you Jack, your comment is much appreciated.
 
At the asking price you have this for , it should be gone . It is a very nice knife and very handy also . You did a great job , I love the handle and furniture it all goes so well together .
 
You must log in or register to reply here.
Back
Top