Question for the Sebenzanistas

EdgePro = accurate and scary sharp edge
Belt grinder = Extremely rapid accurate and scary sharp edge (*)

(*) In the hand of someone who knows how to do.
 
If you really want a sharp edge, with good control over the bevel angles, then I recommend any of the clamping systems followed by some serious stropping or polishing on a paper wheel. While power sharpening is faster it takes lots of practice to do it right. As I have mentioned before, even the manufacturers don't get it right, and they have had many hours of practice. What they don't have is OUR committment to OUR knife, and the time to make sure it's right!
And for S30V and the other wear-resistant steels, "diamonds are a knife's best friend".
Greg
 
JoHnYKwSt said:
I have both a belt grinder and an edge pro. For knives I don't care about I use the belt grinder, but if I want a perfect edge I use my edge pro. If you don't care too much about the aesthetics of your edge you might want to get the belt grinder and save some money. They run about $40.
Click to expand...


But evidently grinders are used to sharpen at CRK (that's what I was told in the email from Heather), so obviously good aesthetics and scary sharpness can be achieved with a grinder. I once received a gift of 200 folders from Frost Cutlery via the Home Shopping Network (thanks grandma). I think they would provide with some valuable practice with the grinder. :)

BTW, got any links to the $40 dollar grinders?
 
All of the above ideas have merit imho.

However, the idea of using a belt grinder on a Sebenza unless you are a knifemaker or professional sharpener versed in belt grinding is spooky.

When I first got my Sharpmaker diamond rods, I damaged a couple of knife points in the process of reprofiling, and did not notice the point damage until I was through because I was so focused on the edge angle...go figure.

I have had nothing but successful sharpening with my Edge Pro since I got it. No point damage (although it is possible). No hours of reprofiling. No guessing about the angle. I don't need the Edge Pro often after I have established a primary bevel I like, but it is great to use to get your knife the way you want it. I maintain the Edge Pro edge with my Sharpmaker and all is well. :)

Try it...you might like it. Or you may prefer an Arkansas stone and your bare hands which I do to relax sometimes.
 
i know it's the "other" forum, but check this out if you are considering a belt grinder

http://knifeforums.com/forums/showtopic.php?tid/776367/

i have all the sharpening systems, plus hundreds of freehand stuff, but always find myself going to the grinder. but get some practice on some inexpensive blades or kitchen knives first, once you get the hang of it, go for it!
 
You must log in or register to reply here.
Back
Top