Question for whoever knows..

Tuff

Tuff

Joined
Jun 15, 1999
Messages
981
What does everyone use to tighten their Cuda's? Every wrench I try seems to small or too big, and it's driving me nuts!
 
Tuff,
Cuda screws are 6 flute Bristol splines.
Best source for wrenches I found is Chapman Manufacturing Co. (860) 349 9228. (They make really neat tool kits that could service almost any knife too.)

Spline wrenches on 1/4" bits cost about $1 each.

Chapman part #'s:
Pivot screws (.072" Bristol spline) CMB-53
Post screws (.060" Bristol spline) CMB-54

Hope this helps.
If all else fails send it back & make me fix it!!
 
You must log in or register to reply here.
Back
Top