Hi Everyone
I just aquired some of Mike Norris ,125 SS damascus in a trade. I would appreciate any good recipes on heat treating/etching process for folder blades.
I am assuming that it is around 1950/350 combination or similar to Devin Thomas SS damascus procedures, but not sure? I would really appreciate anyone that has had good results posting their heat treat and etching process.
Also, does this quench well pressed between aluminum plates as I normally use on SS?
Thanks,
Jon
I just aquired some of Mike Norris ,125 SS damascus in a trade. I would appreciate any good recipes on heat treating/etching process for folder blades.
I am assuming that it is around 1950/350 combination or similar to Devin Thomas SS damascus procedures, but not sure? I would really appreciate anyone that has had good results posting their heat treat and etching process.
Also, does this quench well pressed between aluminum plates as I normally use on SS?
Thanks,
Jon