Random Thought Thread

[Retired UPS Driver]

Keep looking on the other side of the state. If I get a job over there the wife has to agree to sell and move right?

Of course,

 

[Retired UPS Driver]

Retired UPS Driver You must have needed the sleep friend. Enjoy.

YOU get it, Thank you

 

[Murphjd25]

They lied that I’d get a company vehicle. I’m not driving my diesel truck every day, and then to every job site I go to. And definitely isn’t in the budget for a third car.

 

[clinton1]

I feel this.......Who can relate???? yoko ???

 

[yoko]

View attachment 2773902

I feel this.......Who can relate???? yoko ???

Yup hahahahahahaha

 

[Mendoman]

Loaded two cords of hardwood into my dump trailer and drove it 1.5 hours on winding mountain roads today to deliver it. I got to the customer’s house and proceeded to lift the dump trailer to empty it. As it reached its apex, the hitch pulled off of the ball. Luckily the safety chains caught it. It did some damage to my bumper but all in all it could have been a lot worse. I couldn’t figure out what happened as the lock and pin were still engaged on the trailer tongue. Then I realized that the ball hitch had been switched to the 2 inch from the 2 5/8 ball. I then remembered that my neighbor had rented a ditch witch that I hauled for her. At the equipment rental place, I just pulled in and the employees hooked up the trailer and unhooked it when I returned it. Unbeknownst to me they had flipped the ball to the smaller one. Considering to roads I had been on I was really lucky that it waited until then to come off. Always check your balls I guess.

 

[Fonedork]

 

[tinfoil hat timmy]

View attachment 2773902

I feel this.......Who can relate???? yoko ???

mine didnt act so calm..... the instructions were unclear and I didnt know what to do.

Now there is an Elephant in the Minnesota Northwoods. I hope it became a feral mammoth and tore it up.

Man what a ride.

 

[Hatchet_Jack]

Found my first pocket knife to that my grandfather gave me when I was 8 or 10. View attachment 2772878

Very cool man

 

[Murphjd25]

Gosh dang me and the boy caught a doozy of a cold again.

 

[carnifex knifeworks]

Gosh dang me and the boy caught a doozy of a cold again.

There are some crazy bugs going around. Hope you get well quick!

 

[yoko]

Gosh dang me and the boy caught a doozy of a cold again.

I hope both of you feel better soon

 

[adluginb]

Nathan the Machinist or # NotNathan.

since I don’t make knives and have no clue, will 400 F hurt the temper or heat treat on an UF2?

 

[Cap’n Smudge]

Nathan the Machinist or # NotNathan.

since I don’t make knives and have no clue, will 400 F hurt the temper or heat treat on an UF2?

#notnathan
Nathan has stated in the past that the bad number is 500 degrees Fahrenheit.

 

[toker]

#notnathan
Nathan has stated in the past that the bad number is 500 degrees Fahrenheit.

Note to self. Don't use a Carothers when fighting Efreeti.

 

[adluginb]

I’m planning on sending in my UF2 to have it DLC’d to make my own UF blackout version. From what I see it is applied at close to 400 degrees?

 

[tinfoil hat timmy]

I bet no one gets kickass mail this month. like the rest of the month no one will get any mail that they open and are like, man that's cool

 

[tinfoil hat timmy]

I becha

 

[adluginb]

Depends on if I think the Radian Ramjet is kickass that I should get Friday

 

[jlauffer]

Supposed to get an REK Ember 3.5 tomorrow or Friday...