RC6 removing coating and polishing

[Mrbladedude]

I actually ordered an F1 yesterday and should have it hopefully by the end of the week. Been wanting this knife for the longest time.

 

[Mrbladedude]

Yeah...I was trying to be funny (It would've been funnier if I could have pulled off an upper midwest accent like the folks in the move Fargo). My ESEEs are users too. None have that kind of wear but someday!

I am guessing some serious firewood has met it's match in that ESEE-6.

Ya man some thick knotty wood out in the middle of nowhere and in my back yard. I use it all the time to make fires and what not. Its my "Do everything" knife. I love the blade. It takes some serious abuse and begs for more.

 

[sabotage]

How does the coating on the esee line compare to the SOG Seal blade coating. I dont have an esee yet but have found that the SOG coating comes off fairly easy if you actually use the knife like it should be used.

 

[softrockrenegade]

my vote goes to chemical stripping. preferably the aerosol kind you can get at home depot . It will leave the laser engraving in tact unlike sand paper!!! the first pick is after chemical stripping and the second after cleaning it up with an abrasive blaster...