- Joined
- Jan 10, 2010
- Messages
- 1,818
I have two available after a very poor showing at the Janesville Fall Show.
The first is a multi-laminate blade made from 15n20 band saw blades and Aldo 1084. The teeth were left intact and filled with 1084 powder for an interesting pattern. I wanted this one a little heavier in the hand for a stout feel so the blade is 3/16" at the ricasso with minimal distal taper in the handle. Makes for nice balance. Flat ground all the way to edge with slight convex. Very aggressive edge for a smaller knife with thick spine. 10" over all length, 6.5" blade. Handle is claro walnut with copper liners. Sheath is made by me and will hang on left side for cross-draw.
Price is $355 shipped with sheath.
The second is an integral (utility or tactical depending on you!) forged from Nicholson file which are usually 1095. The forged finger flares feel great in the hand and hand rubbed blade shows heat treat line. The profile is based on a Persian fighter. This is a unique and useful little blade.... 8" over all length, 3.5" blade, 1/8" spine.
Price $155 shipped with sheath.
As usual... my knives carry a lifetime guarantee as long as I'm alive and the knife is used in a manner consistent with the design. Will return money after 1 week if the knife is in the condition in which it was shipped.
Paypal accepted to scott@bigrockforge.com
The first is a multi-laminate blade made from 15n20 band saw blades and Aldo 1084. The teeth were left intact and filled with 1084 powder for an interesting pattern. I wanted this one a little heavier in the hand for a stout feel so the blade is 3/16" at the ricasso with minimal distal taper in the handle. Makes for nice balance. Flat ground all the way to edge with slight convex. Very aggressive edge for a smaller knife with thick spine. 10" over all length, 6.5" blade. Handle is claro walnut with copper liners. Sheath is made by me and will hang on left side for cross-draw.
Price is $355 shipped with sheath.
The second is an integral (utility or tactical depending on you!) forged from Nicholson file which are usually 1095. The forged finger flares feel great in the hand and hand rubbed blade shows heat treat line. The profile is based on a Persian fighter. This is a unique and useful little blade.... 8" over all length, 3.5" blade, 1/8" spine.
Price $155 shipped with sheath.
As usual... my knives carry a lifetime guarantee as long as I'm alive and the knife is used in a manner consistent with the design. Will return money after 1 week if the knife is in the condition in which it was shipped.
Paypal accepted to scott@bigrockforge.com
