coiledwire
Platinum Member
- Joined
- Aug 30, 2013
- Messages
- 1,595
*sold* 1st up is a GEC #15 modified by Esnyx. The handle is red micarta with Al mesh layered, and the clear finish has a crackled texture. Mosaic pivot. Black/white/black g10 liners. Easy open with a spear blade. Very small dots on the blade that should be easy to polish out. Very smooth, very light; excellent walk and talk. I've only put a nice sharp edge with the sharpmaker. Minimal pocket time. Esnyx did his usual outstanding work on this knife. *sold*
*sold* Next is a Northwoods Indian River Jack with ebony handles. This is knife is the newer model with CPM-154 blade steel. The edge wasn't very nice from the factory, so I ran it through the sharpmaker. The very tip still needs a bit of work on one side, but the entire edge is nice and sharp. I haven't cut anything more than phone book paper to test the edge. There's a slight gap in the liners. Pull is probably 6+. This knife seems like it will break in nicely and make an excellent user with modern CPM steel. *sold*
*reduced* $100 paypal goods, shipped CONUS
No trades.
1st to post "I'll take it" has dibs.
Thanks for looking!
*sold* Next is a Northwoods Indian River Jack with ebony handles. This is knife is the newer model with CPM-154 blade steel. The edge wasn't very nice from the factory, so I ran it through the sharpmaker. The very tip still needs a bit of work on one side, but the entire edge is nice and sharp. I haven't cut anything more than phone book paper to test the edge. There's a slight gap in the liners. Pull is probably 6+. This knife seems like it will break in nicely and make an excellent user with modern CPM steel. *sold*
*reduced* $100 paypal goods, shipped CONUS
No trades.
1st to post "I'll take it" has dibs.
Thanks for looking!
Last edited:
