How To Remove stripped screw without dremel?

Well, if the ID is smaller, it won't fit over the Shaman's pivot pin. If the ID or OD is larger, it might interfere with other parts and move about the pivot pin which is not optimal. A thicker or thinner washer might make it impossible or very difficult to adjust the pivot satisfactorily and may affect operation.
 
OP This seems like it's really starting to snowball on you.
It might be in your best interest to cut your losses and send it in to Spyderco.
That way, although you are spending more, you are assured that you're getting the exact parts needed.
 
NorthernSouthpaw said:
OP This seems like it's really starting to snowball on you.
It might be in your best interest to cut your losses and send it in to Spyderco.
That way, although you are spending more, you are assured that you're getting the exact parts needed.
Click to expand...
yea unfortunately I think you’re right. Live and learn. Thanks to everyone who gave me advice. I’m going to send it in and just never do that again lol. Thanks again
 
John_94 said:
JDX was an very old account. I used it more when I was younger and would be a bit more rambunctious and then I came back to this site for help and people were judging me based on how I responded in the past which was frustrating so I wanted a fresh start. Like people were going to posts from over a year ago and basing their opinions of me off of that. So I ditched that account and now just looking for actual help.

but the pivot screw that’s stripped it stuck in the stop pin so I can’t access it from the threaded side. But besides the pivot, do you know where I can get a washer? Spyderco CS said they can’t ship international parts
Click to expand...

https://bladeforums.com/members/jdx.374888/

https://www.bladeforums.com/members/john_94.537585/

You are only allowed one account.
Pick which one should be removed.
If you do not pick, I will flip a coin. Your posts using each are equally impolite.
 
John_94 said:
A
can you point out which posts or comments on this account have been impolite? Because I don’t know what you’re talking about. And also, I think you weren’t being the most polite either...
Click to expand...
You are correct, and I apologize and withdraw the last comment.
I had to check both threads, and mistook comments made using your other account for comments made using the current one.
 
knarfeng said:
You are correct, and I apologize and withdraw the last comment.
I had to check both threads, and mistook comments made using your other account for comments made using the current one.
Click to expand...
Okay I understand. Sorry for mix up. Thanks for clearing things up
 
You must log in or register to reply here.
Back
Top