Replacing Coil spring on an S.A.T.

R

Ratinator

Joined
Jul 27, 2005
Messages
16
I was just brainstorming while I was tearing down a Flash II SAR. How about a heavier coil spring to really speed up the S.A.T. actions??

~Jay
CT Specialty Knives
 
Easy, take old spring to hardware, get a new one, bend ends on new and install, hard to tell how many coils to use though, you may have to play awhile.

Don't go too much bigger though or you could cause stop pin to fail or something else. It's kind of like increasing horse power on an engine, it's ok as long as your drive train is up to handling the extra horses... :D

Robbie Roberson :)

P.S. Also read this.........
http://www.bladeforums.com/forums/showthread.php?t=336178&highlight=sog+spring
 
You must log in or register to reply here.
Back
Top