Not sure If I should put this here or in the gear trade...
I have the jaws off of a Phoenix SB cutter rescue tool.
Original tool is here;http://www.phoenixrescue.com/cutters.htm
Approximately- 11" long, 3.5" at the widest point, 1" thick.
http://www.flickr.com/photos/9423338@N02/5678336033/
I don't know what kind of tool steel they are, but they used to cut through B pillars well.
I wanted to get a tomahawk made from one in trade for the other. but I cannot find a blacksmith near me to do that.
What does anybody have to trade?
Open to all kinds weapons, etc. (I have a 14' Trebuchet out near my shop)
I have the jaws off of a Phoenix SB cutter rescue tool.
Original tool is here;http://www.phoenixrescue.com/cutters.htm
Approximately- 11" long, 3.5" at the widest point, 1" thick.
http://www.flickr.com/photos/9423338@N02/5678336033/
I don't know what kind of tool steel they are, but they used to cut through B pillars well.
I wanted to get a tomahawk made from one in trade for the other. but I cannot find a blacksmith near me to do that.
What does anybody have to trade?
Open to all kinds weapons, etc. (I have a 14' Trebuchet out near my shop)
Last edited: