Richlite and 80CrV2 - SOLD

[redsquid2]

This one has two issues:

1. The knife has a small divot in the right-side bevel about 1.25” from the tip and about .125" from the spine. I would say it is .33 mm across = .013”.

2. The sheath has an accidental cut at the top near the rivet. It is about .5” long and does not go all the way through the leather.

Steel: 80CrV2 heat treated by Paul Bos to 61HRC.

Blade: 3 5/16"
OAL: 7 3/4"
Thickness: approx. .105" in the ricasso.

Handle: Richlite phenolic, g10 liners, brass tubing, g-flex epoxy.

Very flexy and thin.

Asking $63 [SOLD] shipped via Priority to your door. I am not currently shipping outside the USA. I prefer PayPal.

Thank you for looking.

Andy

 

[redsquid2]

 

[RobT2]

Could you post a pic that shows the divot in the bevel a little better. Is it near the edge?

 

[redsquid2]

Could you post a pic that shows the divot in the bevel a little better. Is it near the edge?

Yes. To show the divot, I now have a picture up in the original post. The very top picture. The divot is closer to the spine.

Thank you for looking.

 

[cbach8tw]

Nice and looks very handy.