Bailey Knives
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 18, 2004
- Messages
- 3,775
Here is one of my ringed knives. I have not made this model in a while, but I had a friend over to make a first knife, and this was the pattern he chose. I thought I would make one along side him, and here is the result.
The steel is 1095, clay quenched for a hamon. The spine is fully fileworked.
I made the handle a bit longer than my other ringer (my edc) so you could grip it by just the handle, or put your little finger through the ring and both ways are comfortable.
The sheath is kydex with a belt loop that will pivot for horizontal or vertical carry.
Dimensions
Blade - 4 1/4" tip to hanlde
OAL - (to end of ring) 9 1/2"
Price - $175 shipped to CONUS. I prefer paypal, but will accept check or money order.
The steel is 1095, clay quenched for a hamon. The spine is fully fileworked.
I made the handle a bit longer than my other ringer (my edc) so you could grip it by just the handle, or put your little finger through the ring and both ways are comfortable.
The sheath is kydex with a belt loop that will pivot for horizontal or vertical carry.
Dimensions
Blade - 4 1/4" tip to hanlde
OAL - (to end of ring) 9 1/2"
Price - $175 shipped to CONUS. I prefer paypal, but will accept check or money order.
