- Joined
- Oct 26, 2005
- Messages
- 16,812
Rick's younger brother Rocky is making knives part time......
Take a look at this knife
It has 1/8" ATS-34 ss ,hollow ground on a 10" wheel. Full Tapered tang & Mexican Cocobolo with red liners,ss pins & lanyard tube.
It is 8-7/8" OAL,with a 4.5" blade measured tip to handle & a 3.5" cutting edge.That finger groove spot on the tang is about an inch & provides a handle that has a few grips,you can "choke up" on the blade.That Mexican Cocobolo is some good looking tough handle material & the red liners sets it off nice.His fit & finish is really fantastic,nice grind & a very nice & pronounced swedge.All in all,he's doing fantastic work & will only get better
You can pick this up off me for $olddelivered,contact me please if you'd like
This knife comes with a gorgeous fully tooled RH belt sheath by Larry Parsons & his work,too is of the best
Thank You,
-Vince
Take a look at this knife
It has 1/8" ATS-34 ss ,hollow ground on a 10" wheel. Full Tapered tang & Mexican Cocobolo with red liners,ss pins & lanyard tube.
It is 8-7/8" OAL,with a 4.5" blade measured tip to handle & a 3.5" cutting edge.That finger groove spot on the tang is about an inch & provides a handle that has a few grips,you can "choke up" on the blade.That Mexican Cocobolo is some good looking tough handle material & the red liners sets it off nice.His fit & finish is really fantastic,nice grind & a very nice & pronounced swedge.All in all,he's doing fantastic work & will only get better
You can pick this up off me for $olddelivered,contact me please if you'd like
This knife comes with a gorgeous fully tooled RH belt sheath by Larry Parsons & his work,too is of the best
Thank You,
-Vince








Last edited: