Rust on the blade but not on the edge.. Get it off! :P

I've been trying to buy CLP locally for a while, but I can't find any. So I just use RemOil. It's a Remington brand gun oil.

I'll try the 0000 steel wool sometime this week. I'll post follow-up photos when I'm done.

And this MT is retiring after 3 years of use, it's time for change. The KaBar is an excellent knife and a much better cutter than the MT. I got rid of my bad habits of chopping and stabbing the knife into wood, so the KaBar should hold up.

Thanks for the responses. I'll try to post the follow up photos before this thread dies too deep into the forum.
 
The USMC is a decent utility knife, and quite the classic too. I'd go for one of the Becker series for the better slicing performance however. While the USMC's blade is fairly thin, the low saber grind isn't doing its cutting performance any favors.
 
You must log in or register to reply here.
Back
Top