This is a little worker. I wanted to make some blades that were affordable with this steel and decent users. This is one of two. The other is a drop point.
I'll post the drop point in the next day or so.
This is part of my quick and dirty line. The finish is scotch brite belt with a blended convex edge so it was meant to be used. Specs below. Just need to mark it and pack it.
[/IMG]
[/IMG]
[/IMG]
S90V 3.5" cutting edge, 3.75" blade length
OAL 7.5"
carbon fiber with red g10 liners
torx screws with acra weld epoxy to seal it.
peter's ht @ 60-61
Asking $OLD! shipped priority with paypal or us money order. If for any reason you are not satisfied just return it within a week of receiving it, unused, for a full refund. Thanks for looking!
I'll post the drop point in the next day or so.
This is part of my quick and dirty line. The finish is scotch brite belt with a blended convex edge so it was meant to be used. Specs below. Just need to mark it and pack it.
S90V 3.5" cutting edge, 3.75" blade length
OAL 7.5"
carbon fiber with red g10 liners
torx screws with acra weld epoxy to seal it.
peter's ht @ 60-61
Asking $OLD! shipped priority with paypal or us money order. If for any reason you are not satisfied just return it within a week of receiving it, unused, for a full refund. Thanks for looking!
Last edited:
