timos-
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 22, 2012
- Messages
- 2,164
Hi all. I have been using these uhmw sanding backers for shallow hollow ground blade finishing. I made these new ones a little different than the last ones I had. These work well in combination with curved platens.
One of the difficulties in hand sanding knives like yanagi or sashimi knife is getting those lengthwise sanding marks on the concave (urasaki) side of the grind.
0 left
Specs are:
1-3/8" x 5" x 1.5"
The shallow curved edges are opposite the writing.
There are 4 blocks in each set 36, 48, 60, and 72" rad.
I am asking 40 shipped CONUS per set. You can send paypal payment to timostheos@hotmail.com.
I can ship these out tomorrow.
One of the difficulties in hand sanding knives like yanagi or sashimi knife is getting those lengthwise sanding marks on the concave (urasaki) side of the grind.
0 left
Specs are:
1-3/8" x 5" x 1.5"
The shallow curved edges are opposite the writing.
There are 4 blocks in each set 36, 48, 60, and 72" rad.
I am asking 40 shipped CONUS per set. You can send paypal payment to timostheos@hotmail.com.
I can ship these out tomorrow.
Last edited:
