Scandi style EDC in CPM S30V and curly maple

D

Dmitry.M

Feedback: +43 / =0 / -0
Joined
Jun 13, 2006
Messages
1,008
The blade is made of CPM S30V. 4-1/8" long, 1" wide and 1/8" thick at the bolster. Tapered to the tip, flat ground. Heat treated by Paul Boss to 60 HRC.
The finish is sandblasted satin.
The bolster is mokume-gane. My make; copper+nickel silver. The butt cover is made of the same piece of mokume-gane.
The blade has a full length tang going through the handle an tightend with the nut.
The handle is very nice piece of the exhibition grade curly maple. It has a lot of marbeling and rich deep colour. The handle is vacuum treated and polished with carnauba wax.

This knife comes with leather sheath. Pouch style, nice and tight fit. Right side belt loop.

I apologise for the poor pictures. Will take better with the sun light and add more.

I am asking Reduced to $250 for it, shipped CONUS via USPS Priority Insured Mail.
PayPal preferred. Will take the personal check(ship after the check is cleared).
Thank you.
 
Last edited:
I am tellin ya the finish details are excellent and that is what separtes a very high end knife from a very good one. Just superb and wished I had the funds also. keepem sharp
 
The Mokume is excellent! The knife has all the merits of a classic. You are one to keep an eye on my friend.
 
That's a superb knife!
bevels look very thinly ground for great slicing ability. it'd be great to see a pic of the blade from the spine to see the continuous blade tapering to the tip.
Is there in the web a gallery of your other works to have a look at? I'd love to see your other knives.
 
You must log in or register to reply here.
Back
Top