Sears lockback

[know what i mean]

I know much has been discussed in the past about Schrade having made a lot of Sears knives. Is there someone who may have the knowledge of the Sears madels with relation to the schrade counterparts. I picked up a little single blade lockback at the flea market. Tang stamp Sears Stainless, USA #95414. It's solidly made,I believe brass bolsters, wooden handles. It opens and locks tightly, closes a little lightly. Felt it was worth the $5.00. Any insight would be much appreciated. Thanks for your time. :thumbup: Dale H.

 

[sunnyd]

Hiya Dale and Welcome.

Its hard to say without pictures. Perhaps you should post this thread with some photo's over in the Schrade sub-forum here at bf. There is a wealth of knowledge over in there. If it is in good working condition and it was made in the USA, then you nearly stole it for a sawbuck in any case.

Its likely someone else will come along who is more knowledgeable about the Sears pattern numbers.. Good hunting.

Anthony

 

[thawk]

I think I read recently the wooden handled lockbacks for Sears were made by Camillus. After doing a search:

http://www.bladeforums.com/forums/showpost.php?p=5210844&postcount=5

Could not find a picture of that pattern.