Sharpening a cyclone?

If I remember correctly, the angles are about 40 degrees, inclusive. They may vary a bit from knife to knife, but that's a good place to start. Unless you're considering re-profiling, then you'd want to go 30 degrees or less, inclusive, and finish with the 40 degree micro bevel.

Oh, and welcome to the forum! Hang around and ask as many questions as you need...
 
SPXTrader said:
If I remember correctly, the angles are about 40 degrees, inclusive. They may vary a bit from knife to knife, but that's a good place to start. Unless you're considering re-profiling, then you'd want to go 30 degrees or less, inclusive, and finish with the 40 degree micro bevel.

Oh, and welcome to the forum! Hang around and ask as many questions as you need...
Click to expand...

Friendly, pleasant, to the point. VERY nice response SPX. I'm proud of you!:D
 
Hey jm! After last weekend, I'm down on the jar reserves, so I gotta be a good boy and restock! Thanks!

SPX
 
You must log in or register to reply here.
Back
Top