Short Sword and small tanto for sale

N

night man

Feedback: +2 / =0 / -0
Joined
Aug 27, 2010
Messages
199
First post as a knifemaker subscriber.

I have 2 knives up for sale.

First one is a short sword I made recently. 1/4" 5160. Chisel grind. 14" overall length with a 5" handle and a 9" blade. Black and OD Green laminated G10 handles with a hidden lanyard hole on the end. Kydex sheeth. $200 shipped. SOLD


Next is a small tanto. About 7" overall. Chisel ground 3/16" CPM3V. OD green micarta handles. Acid etched blade. Kydex sheath with Large Teklock. $135 shipped (down from $150)



I accept paypal or MO.

Thanks for looking.
 
Last edited:
Nice tanto! Who did the ht and where is the HRC at?

Is there a back bevel on that chisel grind?
 
Thanks. Peters heat treat does all my cpm3v to 60 hrc. I do my own 5160 and high carbon steals in my paragon oven. Aim hardness on the short sword is 58 hrc.

I have been making knives for almost 2 years now and last spring I bought the oven and started doing all my own heat treating on oil hardening steels.

No ,there is no back bevel. I do a light strop on the backside but no pronounced bevel.
 
Now that short sword is wicked! I'll definitely keep my eye out for one of those in the future.
 
I really like the short sword, I have some questions. Would you mind emailing (vwrsi@hotmail.com) me? Thanks.
 
Thanks guys. Right now I am not taking orders because I stay very busy with other things. My knife making has slowed to a couple knives a month (if I'm lucky) and I usually just make one offs to keep it fresh. Once things settle down I hope to start taking orders again.
 
You must log in or register to reply here.
Back
Top