Bill Siegle
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 3, 2000
- Messages
- 6,826
Finally settled on this design after a few attempts. This pattern is a little lighter in the hand without giving up the ability to reach out. I have had this one out testing a couple times but have cleaned it up so now it's ready to go off into the world on new adventures 
17 7/8in overall with an 11 3/8in blade(tip to handle). The blade is fully flat ground from 1/4in thick 5160 with a differentially hardened blade.Scales are natural canvas micarta that is sculpted and finished a little rough(80grit) for better texture. Flared stainless steel tube fasteners and epoxy hold the scales on. Also the tang has been drilled out for weight reduction. Comes with a Kydex sheath. My price on a new one is $475 but this has seen some use so $400***sold*** shipped in the US.
17 7/8in overall with an 11 3/8in blade(tip to handle). The blade is fully flat ground from 1/4in thick 5160 with a differentially hardened blade.Scales are natural canvas micarta that is sculpted and finished a little rough(80grit) for better texture. Flared stainless steel tube fasteners and epoxy hold the scales on. Also the tang has been drilled out for weight reduction. Comes with a Kydex sheath. My price on a new one is $475 but this has seen some use so $400***sold*** shipped in the US.
Last edited:
