The blade is 3-3\4" long, 1" wide, 1/8" thick at the bolster. CPM S30V Stainless Steel, heat treated by Paul Bos to 60HRC. Flat ground and hand rubbed to 1000grit.
I hand carved bolster from a solid piece of type 330 Stainless Steel. Probably would not do it again as it happened to be the Royal PITA. Acantus leaves are carved in 3D on all sides and cover all bolster. Hidden tang goes through the handle and is fixed with the butt nut that is also a lanyard loop. I carved the same motiff on it. The knife is permanently accembled with Locktite epoxy.
The handle is Black Walnut, vacuum treated, polished with carnauba wax. It has some nice figure.
The sheath is very simple. Hand stiched. Pouch type with tight fit. Dyed and polished.
I am asking DROPPED TO $500 , shipping Insured Priority Mail CONUS included.
PayPal preferred.
Thank you.
I hand carved bolster from a solid piece of type 330 Stainless Steel. Probably would not do it again as it happened to be the Royal PITA. Acantus leaves are carved in 3D on all sides and cover all bolster. Hidden tang goes through the handle and is fixed with the butt nut that is also a lanyard loop. I carved the same motiff on it. The knife is permanently accembled with Locktite epoxy.
The handle is Black Walnut, vacuum treated, polished with carnauba wax. It has some nice figure.
The sheath is very simple. Hand stiched. Pouch type with tight fit. Dyed and polished.
I am asking DROPPED TO $500 , shipping Insured Priority Mail CONUS included.
PayPal preferred.
Thank you.
Last edited: