- Joined
- May 12, 2012
- Messages
- 846
Hi everyone, I have a small kiridashi for sale that I finished up yesterday.
Specs:
3/32" 1095 steel heat treated by Darrin Sanders to 60-61Rc
4" OAL
Right hand chisel ground with asymmetric microbevels. To sharpen just strop the left hand(unground) side.
Forge finish
I made a basic leather sheath and a lanyard that will go with the kiridashi.
This one is a heck of a cutter and freaky sharp! I tested the sharpness by cutting writing off of printer paper without going through! This little kiridashi should make a great craft knife, it's perfect for making small, clean precision cuts.
Asking $SOLD shipped CONUS.
I take Paypal, check and USPS money order. If you want to buy this knife, post "I'll take it" in this thread then email me at markellmtthw@aol.com and confirm that you want it and let me know how you want to pay and where it needs to go.
Some pictures:
Any questions or comments let me know.
Thanks for looking
Specs:
3/32" 1095 steel heat treated by Darrin Sanders to 60-61Rc
4" OAL
Right hand chisel ground with asymmetric microbevels. To sharpen just strop the left hand(unground) side.
Forge finish
I made a basic leather sheath and a lanyard that will go with the kiridashi.
This one is a heck of a cutter and freaky sharp! I tested the sharpness by cutting writing off of printer paper without going through! This little kiridashi should make a great craft knife, it's perfect for making small, clean precision cuts.
Asking $SOLD shipped CONUS.
I take Paypal, check and USPS money order. If you want to buy this knife, post "I'll take it" in this thread then email me at markellmtthw@aol.com and confirm that you want it and let me know how you want to pay and where it needs to go.
Some pictures:
Any questions or comments let me know.
Thanks for looking
Last edited:
