i originally intended to make something resembling a patchknife, but i'm not sure this quite fits the typical vision of such. either way, it would make a nice small EDC belt knife or neck knife, and it would do just fine in the woods for lighter duty tasks (no chopping down trees 
)
Blade: 1/8" thick, 1/2" wide, 3" long
Handle: hidden tang maple with danish oil finish, 1/8" brass pin, 3 5/8" long
Steel: O1
Grind: full convex
Finish: 9 micron belt finish, unfinished spine
the wood has some nice subtle figure to it:
SOLD$30 shipped to continental US, outside US shipping at buyer's risk and extra expense. shipped when payment is recieved and processed.
i accept USPS money orders and paypal to modelmaster @ sbcglobal.net (remove the spaces around and @ when sending)
an "i'll take it" posted in this thread reserves the knife for you pending funds. pm or email for mailing address if using a MO.
questions etc always welcome. thanks for looking
)Blade: 1/8" thick, 1/2" wide, 3" long
Handle: hidden tang maple with danish oil finish, 1/8" brass pin, 3 5/8" long
Steel: O1
Grind: full convex
Finish: 9 micron belt finish, unfinished spine
the wood has some nice subtle figure to it:
SOLD$30 shipped to continental US, outside US shipping at buyer's risk and extra expense. shipped when payment is recieved and processed.
i accept USPS money orders and paypal to modelmaster @ sbcglobal.net (remove the spaces around and @ when sending)
an "i'll take it" posted in this thread reserves the knife for you pending funds. pm or email for mailing address if using a MO.
questions etc always welcome. thanks for looking
Last edited:
