CPE_Knives
Knifemaker / Craftsman / Service Provider
- Joined
- Oct 29, 2012
- Messages
- 1,720
Good Afternoon,
This blade is made from full flat ground 26C3 hand rubbed to 2000 and etched to expose the hamon. The spine is rounded where the thumb rests and square for the last couple inches for use with a ferro rod. Handle is Ultrex Suretouch which is a rubber and G10 composite. One of my favorite material feels hard like G10 but has a rubber texture.
Sheath is kydex and comes with a Tek-Lok setup for scout carry. It can be easily changed to a vertical orientation on either side.
Price Sold , shipping is included to continental United States via USPS flat rate box. Preferred payment is via paypal.
Blade Steel: 1/4" 26C3
Grind: Full Flat
Cutting Edge: 5 1/4" measured in front of the sharpening choil
Handle Material: Camo pattern Ultrex Suretouch and stainless pins
Overall Length: 10"
Sheath: Kydex with included Tek-Lok
If you would like additional pictures or have questions please contact me at cpeknives@gmail.com
For an additional $30 I will include and mount one of these 5/16" ferro rods. They are antler, rosewood and Kingwood.
Comments are welcome thank you for looking,
Paul
This blade is made from full flat ground 26C3 hand rubbed to 2000 and etched to expose the hamon. The spine is rounded where the thumb rests and square for the last couple inches for use with a ferro rod. Handle is Ultrex Suretouch which is a rubber and G10 composite. One of my favorite material feels hard like G10 but has a rubber texture.
Sheath is kydex and comes with a Tek-Lok setup for scout carry. It can be easily changed to a vertical orientation on either side.
Price Sold , shipping is included to continental United States via USPS flat rate box. Preferred payment is via paypal.
Blade Steel: 1/4" 26C3
Grind: Full Flat
Cutting Edge: 5 1/4" measured in front of the sharpening choil
Handle Material: Camo pattern Ultrex Suretouch and stainless pins
Overall Length: 10"
Sheath: Kydex with included Tek-Lok
If you would like additional pictures or have questions please contact me at cpeknives@gmail.com
For an additional $30 I will include and mount one of these 5/16" ferro rods. They are antler, rosewood and Kingwood.
Comments are welcome thank you for looking,
Paul
Last edited:
