Robert Erickson
Knifemaker / Craftsman / Service Provider
- Joined
- Feb 2, 2014
- Messages
- 2,882
I've got a nimble little 3V Kiridashi up for grabs tonight. It's 0.1" 3V steel heat treated by Peter's to RC60. The Kydex has a belt loop attached by Chicago screws so it can be reversed if desired for left hand carry. It should make a nice little utility knife.
SPECS:
OAL: 6"
Blade: 2.25" cutting edge, 0.5" grind height, 400 grit belt finish on flats and bevels
Steel: 0.1" 3V heat treated by Peter's to RC60
Sheath: Kydex
$SOLD + $7 shipping within the US
Post "I'll take it" here in this thread and then PM or email me for arrangements
Paypal, checks and money orders accepted
Comments/Questions/Critiques welcome.
Thanks!
fullsizeoutput_466 by Robert Erickson, on Flickr
fullsizeoutput_467 by Robert Erickson, on Flickr
fullsizeoutput_464 by Robert Erickson, on Flickr
fullsizeoutput_465 by Robert Erickson, on Flickr
fullsizeoutput_468 by Robert Erickson, on Flickr
SPECS:
OAL: 6"
Blade: 2.25" cutting edge, 0.5" grind height, 400 grit belt finish on flats and bevels
Steel: 0.1" 3V heat treated by Peter's to RC60
Sheath: Kydex
$SOLD + $7 shipping within the US
Post "I'll take it" here in this thread and then PM or email me for arrangements
Paypal, checks and money orders accepted
Comments/Questions/Critiques welcome.
Thanks!
fullsizeoutput_466 by Robert Erickson, on Flickrfullsizeoutput_467 by Robert Erickson, on Flickrfullsizeoutput_464 by Robert Erickson, on Flickrfullsizeoutput_465 by Robert Erickson, on Flickrfullsizeoutput_468 by Robert Erickson, on Flickr
Last edited: