Cliff Carter Knives
Knifemaker / Craftsman / Service Provider
- Joined
- May 30, 2011
- Messages
- 748
Good evening forum members, hope you all had a great weekend. Today I have one of my Cliff Raiders available:
Steel: ProCut
Rc: 61-62
Thickness: 1/8”
OAL: 7.6”
Blade: 3.5”
Handle: Textured Desert Ironwood over OD G10 liners, silicon bronze pins and OD G10 tube
Finish: Midnight double stonewash
Sheath: Kydex, drainage hole and tube, Ulticlip included.
Beautiful ironwood handle over OD G10 liners/tube and secured with silicon bronze pins. Took the grind just a bit higher on this one and it cuts like a laser. Very impressed with the edge that ProCut takes. Sheath locks up tight with easy deployment. Subdued laser engraved makers mark and steel type mark on opposite side.
This one is $sold shipped via Zelle or PayPal F&F. $sold if paying G&S. Conus only for now, thank you for checking out my work, it’s much appreciated!
Steel: ProCut
Rc: 61-62
Thickness: 1/8”
OAL: 7.6”
Blade: 3.5”
Handle: Textured Desert Ironwood over OD G10 liners, silicon bronze pins and OD G10 tube
Finish: Midnight double stonewash
Sheath: Kydex, drainage hole and tube, Ulticlip included.
Beautiful ironwood handle over OD G10 liners/tube and secured with silicon bronze pins. Took the grind just a bit higher on this one and it cuts like a laser. Very impressed with the edge that ProCut takes. Sheath locks up tight with easy deployment. Subdued laser engraved makers mark and steel type mark on opposite side.
This one is $sold shipped via Zelle or PayPal F&F. $sold if paying G&S. Conus only for now, thank you for checking out my work, it’s much appreciated!
Last edited:
