*SOLD*Custom Victorinox SAK Mod

[Spikediesel]

I always use my own scales but I have boxes of Alox scales laying around so I decided to make some unique pieces with them. This is what I call the EMT, it’s a two layer consisting of scissors, a cap lifter (I like them as a pry tool) and a sheepsfoot blade. On the back side scale I have machined in a 1/4 hex bit driver and an oxygen wrench. The tools are riding on precision ground hardened stainless pivot barrels and everything is held together with torx screws. And some advice that is echoed through the SAK Modding community: Since this knife is held together with screws, there may be a desire to take it apart. The screws are adjusted properly upon assembly and set with blue loctite. Please know I do not recommend disassembly of these knives, there is tension on the back springs that make reassembly difficult. The price is $old shipped in the USA, there are no bits included. Thanks for looking!

 

[conndcj]

I must have this. IM inbound

 

[RIP Dequincy Jynxie]

you need to make more of these OP

(seriously, please)

is that a copper liner I see in there?

 

[Spikediesel]

you need to make more of these OP

(seriously, please)

is that a copper liner I see in there?

No, but I did have one in there at one point during assembly, and don’t worry there’ll be more

 

[BogdanS]

Excellent looking knife, i love the precision work and attention to details - well done Spikediesel my dear brother, very well done!

All the best, God bless,
Bogdan

 

[Spikediesel]

Excellent looking knife, i love the precision work and attention to details - well done Spikediesel my dear brother, very well done!

All the best, God bless,
Bogdan

Thank you for the kind words! I’ve been eyeing your incredible craftsmanship as well!

 

[BogdanS]

You are too kind my dear brother, thank you so much for the nice words!

All and only the best, God bless,
Bogdan