- Joined
- Aug 31, 2011
- Messages
- 3,119
SOLD:
OAL: 7 1/4"
Blade Length: 3 1/8"
Thickness: .098" behind the plunge line, thinner in front of it.
Steel: 80CrV2, heat treated by Paul Bos for 61RC.
It does have my mark engraved on the left-side bevel, but the light washed it out.
Handle: Natural bubinga, sanded to 1200 grit, then finished with paste wax, stainless pins, G-Flex epoxy.
Blems: tang was not perfectly flat when I glued the handle on. Some light-colored dust got into the epoxy at the front of the left handle scale and I could not get it out. You can see this in the pictures. Stitching went astray at the tip of the sheath, and there are a few scuffs on the back side of the sheath.
The white spot is lint:
[sold for]$45, which includes Priority shipping TYD in USA. PayPal preferred. No other destinations please.
OAL: 7 1/4"
Blade Length: 3 1/8"
Thickness: .098" behind the plunge line, thinner in front of it.
Steel: 80CrV2, heat treated by Paul Bos for 61RC.
It does have my mark engraved on the left-side bevel, but the light washed it out.
Handle: Natural bubinga, sanded to 1200 grit, then finished with paste wax, stainless pins, G-Flex epoxy.
Blems: tang was not perfectly flat when I glued the handle on. Some light-colored dust got into the epoxy at the front of the left handle scale and I could not get it out. You can see this in the pictures. Stitching went astray at the tip of the sheath, and there are a few scuffs on the back side of the sheath.
The white spot is lint:
[sold for]$45, which includes Priority shipping TYD in USA. PayPal preferred. No other destinations please.
Last edited:
