Sold Out - M390 Stainless Steel PM 3,4 mm thick - Hunter and few neck knives

[KornalskiKnives]

For sell - PayPal - adam@kornalski.com

I. Hunter with M390 Bohler Stainless PM tools steel 3.4 mm thick.
HeatTreated upto 60 HRC for max wear resistance.
G10 Desert Tan red linners on scales
Blade stonewashed after glassblasting
ABS 2 mm black with big TekLok and codura belt loop.
OAL: 255 mm, Blade: 125 mm (~5").

Asking: SOLD.

Brown is SOLD

-------------------------------------------------------------------------------------------
I. ODCMini with M390 Bohler Stainless PM tools steel 3.4 mm thick.
HeatTreated upto 60 HRC for max wear resistance.
G10 Orange with black linners or white on scales
Blade stonewashed after glassblasting
ABS 2 mm black neck sheath with holes fit big TekLok.
OAL: 175 mm, Blade: 85 mm (3,5").

Asking: SOLD for DHL fast shipping.

MODCI & II

MODC III

MODC IV

MODC V

------------------------------------------------------------------------------------------------
I. AgorMini with M390 Bohler Stainless PM tools steel 3.2 mm thick.
HeatTreated upto 60 HRC for max wear resistance.
Brown Canvas Micarta with red liners on scales
Blade stonewashed after been glassblasted
ABS 2 mm black neck sheath with holes fit big TekLok.
OAL: 175 mm, Blade: 85 mm (3,5").

Asking: SOLD for DHL fast shipping.

 

[HoldTheMayo]

Which knife do you thinks performs better in an edc/food-prep/general tasks type roll? (Of the two 3.5” blades)

 

[KornalskiKnives]

Which knife do you thinks performs better in an edc/food-prep/general tasks type roll? (Of the two 3.5” blades)

Most of my customers say - "the more blade the better" or "it is impossible to have too much blade..."
So I will choose MiniODC as the most of my customers - but think both of them will do the job...

Adam

 

[RyanSean97]

Do you have any of these left?

 

[KornalskiKnives]

Do you have any of these left?

All gone to my reseller in Poland. Many of them are still available in his webshop.

A.