*SOLD* S35VN Clip Point Hunter/Skinner in Redwood Burl

Robert Erickson

Knifemaker / Craftsman / Service Provider
Feedback: +56 / =0 / -0
Joined
Feb 2, 2014
Messages
2,882
Hey guys I just finished up this hunter/skinner. The plunge-less blade is thin S35VN that has a full flat grind down to 0.015" then convex to near zero. The handle is exhibition grade stabilized Redwood burl. The guard is bronze and the anterior face is textured. The spacer is black G10. This is a very light and nimble blade. The sheath is stacked leather.

SPECS:
OAL: 10"
BLADE: 5" long, 1 3/8" wide, plunge-less, full flat grind with convex edge, satin finish.
STEEL: 0.1" S35VN heat treated by Peter's to RC61.
HANDLE: Exhibition grade stabilized Redwood Burl, Bronze guard with textured anterior face, black G10 spacer.
SHEATH: Handmade stacked leather.
$SOLD Shipped CONUS international buyers welcome shipping extra.
Post "I'll take it" here in this thread and then PM or email for arrangements.
Paypal, Venmo, checks and money orders accepted.
Comments/Questions/Critiques welcome.
Thanks!

fullsizeoutput_59a by Robert Erickson, on Flickr

fullsizeoutput_59b by Robert Erickson, on Flickr

fullsizeoutput_59d by Robert Erickson, on Flickr

fullsizeoutput_59e by Robert Erickson, on Flickr

fullsizeoutput_59f by Robert Erickson, on Flickr

fullsizeoutput_5a0 by Robert Erickson, on Flickr

fullsizeoutput_5a1 by Robert Erickson, on Flickr

fullsizeoutput_5a2 by Robert Erickson, on Flickr

fullsizeoutput_5a3 by Robert Erickson, on Flickr

fullsizeoutput_5a4 by Robert Erickson, on Flickr
 
Last edited:
Back
Top